Plating Help US 10/11 - With Lower Right Plating Dot

Good day to all,

Getting back to looking at my 10/11s making a calendar of cancels. Given the lower right guide dot I thought this might be a target for plating. Using the plating wizard tool (US Classics Society) narrows this down a bit but I am unable to make a final determination. What I believe I see that may help ..

- the lower right guide dot is just to the outside of the right frame line
- the the right frame line seems to advance just past the top frame line.
- the bottom frame line does not extend all the way over to the left frame line (small gap in corner)
- no inner frame lines

Your thoughts/input are appreciated.

I also believe this to be a blue Meridian, NY cancel.



Thanks
Hobsun

If you are going to try plating the stamp, you should be able to find it on Plate 6 or 7.

Sinclair,

Thanks, that helped narrow this down quite a bit. Based on my belief that the right frame line runs up a bit past the top frame line, I see 63R7 as a potential candidate. Any thoughts are appreciated.

Hobsun

63R7 is definitely not it. The right frame lines of the two stamps are markedly different when comparing spacing between design and frame line.

Sinclair,

Obviously you are correct, I missed that one. I was focused on the right frame line extending at the top. I will keep looking.

Thanks

26R7