Stamp Community Family of Web Sites
Thousands of stamps, consistently graded, competitively priced and hundreds of in-depth blog posts to read








Stamp Community Forum
 
Username:
Password:
Save Password
Forgot your Password?

This page may contain links that result in small commissions to keep this free site up and running.

Welcome Guest! Registering and/or logging in will remove the anchor (bottom) ads. It's Free!

Roulette And Hyphen Hole Gauge

 
To participate in the forum you must log in or register.
Author Previous TopicReplies: 1 / Views: 2,131Next Topic  
Pillar Of The Community

United States
1510 Posts
Posted 05/04/2018   12:53 am  Show Profile Bookmark this topic Add Timm to your friends list Get a Link to this Message
I have several different perforation gauges.

I was wondering if a Roulette and Hyphen Hole Gauge exists?
Send note to Staff

Rest in Peace
United States
1738 Posts
Posted 05/05/2018   6:06 pm  Show Profile Bookmark this reply Add James Drummond to your friends list  Get a Link to this Reply
Hi

Yes, and I'm sure that you already have one.

Roulettes and hyphen holes are measured by counting how many "cuts" there are in a distance of 20 millimeters.

So, all you need is a small ruler.

Many perforation gauges have a short metric ruler on them specifically to measure roulettes, etc.

Jim
Send note to Staff  Go to Top of Page
  Previous TopicReplies: 1 / Views: 2,131Next Topic  
 
To participate in the forum you must log in or register.

Go to Top of Page

Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Stamp Community assumes no liability for errors. Copyright 2005 - 2026 Stamp Community Family - All rights reserved worldwide. Use of any images or content on this website without prior written permission of Stamp Community or the original lender is strictly prohibited.
Privacy Policy / Terms of Use    Advertise Here
Stamp Community Forum © 2007 - 2026 Stamp Community Forums
It took 0.13 seconds to lick this stamp. Powered By: Snitz Forums 2000 Version 3.4.05