It is difficult. The rotary press stamps are a little bit (a hair) taller. The design on flat plate press stamps (#1041) is 22.7mm high, and on the rotary press stamps (#1041B) the design is 22.9mm high.
Hello. After reading the above information I still had a question. When measuring the height do we measure at the edges of the design, or at the extremes of the perfs. After measuring according to the given instructions, I'm pretty sure its between the edges of the design element, and not from perf to perf. I'm guessing and would appreciate help. Blessings, jack316
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Stamp Community assumes no liability for errors. Copyright 2005 - 2026 Stamp Community Family - All rights reserved worldwide. Use of any images or content on this website without prior written permission of Stamp Community or the original lender is strictly prohibited. Privacy Policy / Terms of UseAdvertise Here
Posted 03/23/2008 9:12 pm
